UPDATE: the new 2.0 model needs to be printed with supports, but it is worth it due to the highly improved stability, drawing quality and 2 point mounting for pen, no wigling, no detail loss!!! (it can also work with a blowerfan duct)

Print settings: Any fillament, 60-100% infil with grid pattern, supports depend on model

1. install a pen that writes smooth lower than the nozzle
2. convert an image to svg and then to stl using links below (in the svg2stl use 0.8 height)
3. put the stl on the build plate in prusaslicer to the top right corner
4. now home your printer and than find the z offset using control
5. put your z offset in the slicer in printer settings-general
6. put “G4 P45000” in custom g-code before purge
7. now slice the stl image with the correct pen thickness and make sure its 1 layer then start the print without the plotter atachment and no fillament with the cut down paper secured on the build plate
8. after the printer heats up and finnishes bed leveling completely attach the plotter as quick as possible (if you turned the heating off you only have 45 seconds)
9. Enjoy!!! ;)