This is a Hueforge design of the iconic Split Rock Lighthouse in Minnesota on Lake Superior. 

You can scale the model but do not change the Z height. You can make it with or without an AMS by adding pauses to change the filament. If using a single AMS just set the first and last color the same and then swap them out after the first one is done. 

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 146.63x220mm in size
You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 3.2mm and the Actual Thickness is 2.88mm

Filaments Used:
    PLA+ Sunlu Black  Transmission Distance: 0.6
    PLA+ Sunlu Blue  Transmission Distance: 4
    PLA+ Sunlu Red  Transmission Distance: 6
    PLA+ Sunlu Sunny Orange  Transmission Distance: 8
    PLA+ Sunlu White  Transmission Distance: 5
This print uses 5 unique filaments

Swap Instructions:
    Start with Black
    At layer #10 (0.88mm) swap to Blue
    At layer #16 (1.36mm) swap to Red
    At layer #22 (1.84mm) swap to Sunny Orange
    At layer #25 (2.08mm) swap to White for the rest.