Hello, fellow makers! I’m excited to share with you my first creation, the HandleHug Doorstop. This project was born out of a personal frustration I think many of us have faced: the annoying tendency for doorstops to disappear just when you need them most. Living in a place where doorstops are not only expensive but also easy to lose, I decided it was time to design a solution tailored to my needs.

This doorstop is more than just a block to prop your door open. It features a hole that allows it to be hung on a door handle. This means no more misplaced doorstops (at least for me)! When you don’t need it, just hang it on the handle - it’s always there when you need it again.

The HandleHug Doorstop measures 80cm in length, with a width of 30cm and a height of 15cm

I hope you find this as useful and satisfying to make as I did. It’s a simple solution, but sometimes, those are the ones that make the biggest difference in our daily lives. Happy printing!

I'm also excited to mention that if the HandleHug Doorstop sees enough interest and success, I plan to design additional versions to accommodate the wide variety of door handle sizes found in homes around the world. Your feedback and support could lead to a whole range of HandleHug designs, tailored to fit any door handle you might encounter.

Measurements: 80cm in length, with a width of 30cm and a height of 15cm. The hole designed to fit around your door handle is 15cm in diameter.

Printed it on an Ender 3 V2 Neo, PLA 15% infill