This is a single part non-stacked version if you don't have an AMS of [https://makerworld.com/en/models/1927235-gridfinity-lightweight-stackable-base-plates#profileId-2068478](https://makerworld.com/en/models/1927235-gridfinity-lightweight-stackable-base-plates#profileId-2068478) for those who don't want to break apart the other one to make a profile.

I would still recommend printing 1 layer of support material for the peanuts and then manually swapping them, but if you have good bed adhesion you can print without the raft of support material.

Spacers system is uploaded separately here [https://makerworld.com/en/models/1927579-gridfinity-lightweight-spacers#profileId-2068879](https://makerworld.com/en/models/1927579-gridfinity-lightweight-spacers#profileId-2068879)

Bins are also available here [https://makerworld.com/en/models/2258913-djr-engineering-gridfinity-bin-catalog#profileId-2460951](https://makerworld.com/en/models/2258913-djr-engineering-gridfinity-bin-catalog#profileId-2460951) 

Feel free to browse my other gridfinity models. [https://makerworld.com/en/collections/4365706-djr-engineering-gridfinity](https://makerworld.com/en/collections/4365706-djr-engineering-gridfinity)

• Peanut Plate Removal 
  • Recommend and puddy knife and just sliding it under all the way down instead of trying to peal it off.  If you try to just peal it off it will likely just knock off all the peanuts from the support and make installation a little more tedious.  Ideally you just leave them on the strip till you need them.
• A1 Mini
  • I have confirm the following sizes in the Smaller than 5x5 profiles will fit on the A1 Mini, but you may just need to move the prime tower inside one of the openings like is done on some of the larger trays.  It may throw a warning, but I have had no issues.  The only reason it doesn't list the A1 Mini is because some of the larger parts fail the fit check in the profile.
    • 1x2, 1x3, 1x4, and 1x5
    • 2x2, 2x3, and 2x4
    • 3x3 and 3x4
    • 4x4