Had this idea pop into my head and while I'm no professional 3D designer, I wanted to make it happen.

Printed as 4 separate plates and assembly is rather straight forward.

Apply Glue to the base as shown:

Glue Knob pin and fake gear to the bar and attach Knob:

Tie rubber band to bar then feed through the bottom of the base before attachment.

Clicker used:

[https://www.amazon.com/BlingKingdom-Replacement-Mechanical-Keyboard-Dustproof/dp/B0DSHTPSL3/ref=sr_1_6](https://www.amazon.com/BlingKingdom-Replacement-Mechanical-Keyboard-Dustproof/dp/B0DSHTPSL3/ref=sr_1_6)