Case for the OrangePi - Zero 256

The model consists of 2 parts, the base and the lid, that snap together. All ports of the OrangePi and the SD card are accessible while it is in the case. The lid has a hole for the antenna to stick through. 

Assembly

• Before placing the Pi in the case, remove the SD card, otherwise it will not fit. 
• To place the Pi in the case, first insert the ethernet and USB port at an angle in their respective holes. 
• Gradually lower the angle of the Pi while wiggling it around slightly. You may need to bend the back of the case slightly to make it fit. 
• Once the board is in, shift is all the way to the back of the case and press on the corners of the PCB so that the ports on the back allign with the holes of the case.
• Insert your SD-card.
• Route the antenna through the hole on the lid.
• Place the lid on the base. Make sure it snaps into place. 

Troubleshooting

• If the antenna does not seem to fit in the hole in the lid, there might be some debris blocking it. Try cleaning the hole using an exacto knife or some sandpaper. 
• If the lid does not properly fit on the base, verify that the overhangs of the clips on the base are neat. If not, clean them.

Finally

This is my first model on MakerWorld. Any feedback is welcome :)

If you like this model, consider boosting.