While there are countless other dragons similar to this, I decided I would like to try my hand at my own. I think it came out perfect and I am excited to finally get to share it on MakerWorld. This design took quite a bit of time for me to perfect, so I hope y'all enjoy it!

Key Features:

• Fully articulated and flexible segments
• 28cm (11in) long serpent dragon design
• Single and multi-color profiles available

Printing Notes:

• If a piece of the print pops off mid-way, its usually due to bed cleanliness, not the settings. If this happens to you, please clean your bed with soap and warm water, or even isopropyl alcohol. Reviews work best when focused on the model and profile settings itself.
• After printing: Some joints, such as the wings, may be slightly stuck, but if you gently wiggle and bend the joints, they should articulate nicely.
• Please keep ratings focused on the performance of the settings themselves, not on model quality or issues caused by printer setup or maintenance.
  • Print profiles can: only adjust slicer settings such as temperatures, speeds, layer heights, and color assignments.
  • Print profiles cannot: affect your printer’s hardware, firmware behavior, AMS loading, bed adhesion, filament condition, or any maintenance-related issues.

Terms of Use:

While I fully encourage people to print my models and give them to friends or family, I want to make it known that I do NOT permit this or any of my models to be sold in any way, shape, or form. I post my models online for free for people to enjoy, not for people to make profit on. Commercial use is prohibited.