NO A1 MINI SUPPORT

When I looked on makerworld for a large nerf/airsoft target that wouldn't break with that plastic nerf dart in the picture I printed, I couldn't find one!

That's where this target comes in.

The ‘frame’ holding the target plate up is light, has lightning infill and the target plate itself is only 0.5cm thick to help save filament but fear not because it has 8 WALLS and 90% GYROID INFILL   (its the strongest and most impact resistant I could make with PLA with my very limited knowledge).  …and its fully print in place

when I shot a 2cm test plate with my Xshot longshot and it left only a small mark, even when I shot it twice and even 3 times in the same spot 

(which probably wouldn't happen anyway on a 250mm target). 

DISCLOSURE

I've never printed the full target before so I don't know how well the whole thing will hold up but if the test cuboids are anything to go by, Id say it'd hold up pretty well. 

Feel free to modify it as you want and add remixes to make it stronger, different materials, stand up better, I don't mind.