Hi everyone,
since many of you really liked the Minecraft Frog but also mentioned the filament waste and long printing times, I redesigned the whole model. I’m now happy to present the Minecraft Frog without the need for an AMS. The parts can be secured with super glue, though I designed them to fit tightly enough that they should hold well even without any adhesive (so that kids don´t need to use glue). 

Simply follow the assembly instructions:

1.remove the supports, beginning from the back.        2.push in the mouth and the tongue.

3.first put on the green parts of the eyes. Then push in the white and black parts from the side to fit tightly (as shown in the picture).

Dimensions:

Height: 3.0 cm

Width: 5.5 cm

Length: 4.0 cm

Please note that this model is not an alternate print version of the previous Minecraft Frog, as many design changes had to be made. Because of this, the frog is a completely new model. Also I used an other green as in the previous model. The quality of the model should be the same.

Thanks for your support! As always I´m excited to read your feedback!