Fun dragonfly to display! 

Dimensions: from top of left wing to top of right wing: 280mm and from nose to end of tail: 94mm. Thickness: 10mm, with 11mm at the taller raised areas.   

I have it scaled to 106% to fit it diagonally on the build plate to get it printed nice and large.

Note: if you scale down, there are some thin areas, you may run into issues.  I have not printed it any smaller than this. 

But you could definitely scale the thickness down. 

There is not a hanging hole on the back, but there is a small hole in the center below the head, easily can hang on a nail. 

Note: there are a few raised areas on the body/wings for decoration.  You can either display right side up or display with the backside, which has the prettier texture from the build plate.  Photos show both front and back. 

I plan to drybrush mine with gold paint :-)

Printed with Sunlu Black PLA black on my Bambu A1.

Please post photos if you print, I'd love to see your dragonflies!