Cool and really low profile-retractable cup holder.

Tested it with full glass of water and a can of beer, holds them safe and snug.

A bit of asembly is needed:

• the upper swing and swing arm - i used a bit of stronger filament and a plier to push it through
• then the swing asembly goes on the case bottom
• above it the case mid
• next comes Top part (making sure that the lip goes behind the swing asembly)
• lastly the Case cap

Each part is named in the 3mf file, use that to identify the order of assembly

This way the need for supports is very minimal, you will need some (i used tree - slim)

For fitting it under the desk you will need 4x 3.5x25 wood screws.