What is it?

This is a replacement part for the Moonlander keyboard “Platform” accessory from ZSA: [https://www.zsa.io/moonlander/platform](https://www.zsa.io/moonlander/platform)

Both sides are included as separate plates.

How to print

It is printed on it's side to make the pegs on the top and bottom stronger, and to reduce the amount of support needed.

I set it up to use 0.16mm layer height in Bambu Studio to improve the curvature resolution a bit.
Two of my prototypes failed when printing (not sure what happened), but slowing the print down to 50% fixed it for me both times. If you are having issues, consider slowing it down.

Why?

It broke for me and I needed a replacement, but could not find a model online, so I designed my own from measurements. The original version seems to be made from some very brittle plastic, and easily fractures when tightened. The print has so far seemed much stronger, even when tightened harder.

Most measurements are accurate, but some where adjusted manually until it fit perfectly when printed on my A1 Mini.