I wanted to see if I could design and print a corner spline jig for my router table. And guess what? I can. This was made to work with my Bosch router table. If you are going to use it I am not liable if something goes wrong on your router table. I have used it and it feels really strong with the current settings. I used 8 M5 20mm bolts, 8 M5 50mm bolts, 16 M5 nuts, 16 M5 washers and 8 M5 locking washers. the washers all go on the clamping blocks. This is not an entry level jig, I hope to make more versions of this with nicer features that would make it more beginner friendly. Feel free to boost me to support that endeavor.