Rule Mandalore!

The Darksaber is here. My take on this iconic saber requires no ams, supports, or glue to assemble.

Add it to your collection and be sure to check out my other lightsabers!

Be sure to check out my other models and sabers!

[https://makerworld.com/en/collections/14478910-lightsabers](https://makerworld.com/en/collections/14478910-lightsabers)

Filaments used:

Sunlu silk grey, Sunlu silk black

To assemble

Start with the grip, stack the silver and black rings onto the tube. The top and bottom have a

 different taper with the more open end facing up. 

Next slide the bottom ring dovetail up the back of the upper grip and snap the other three rings on from the end

starting with the large ring working your way out. There is a notch in the rings to allow for 

expansion.

Place the upper and lower grips together, use the alignment pin in the bottom of the 

lower grip, place the pommel over the pin and bolt the grip together.

You can use a 3/8 hex tool or print the included tool if you'd like.

Put the cross guard over the grip. This locks the tops of the trip in place. Then slide the emitter shield 

into the shroud and place the shroud over the guard and use the bolt to lock it together.

Press in the round button at the front and your saber is complete.