The surface where I placed my AMS2 was not completely flat and the ventilation hole on the bottom was getting blocked.

I designed these spacers to increase the height of the AMS 2, but they will works just as well with the regular AMS.

Because they are printed from TPU they will reduce the sound and vibrations a little as well.

A profile for PLA and PETG is also available, but TPU is recommended.

The standard riser feet height is 10mm, I have also added 20mm and 30mm.

20mm Works very well when the AMS is on top of the printer so its easier to see inside the printer.

Most available spacers align on the very small edge of the foot, in my experience this didn't work very wel.

I made the foot a bit higher so it can be aligned on the housing of the AMS, which is much easier to do when your AMS is fully loaded with filament. They can also be used on all corners, no troubling with left and right or front and back version.