I could not find a spool holder for the Bambulab P2S which fully satisfied me, I do not have enough space on the back of the printer to use the mount that came with it.

Main Design Aspects:

• Re-uses original filament guide.
• Mounts on the screw holes intended for the spool holder.
• Two M3 x 15mm screws needed.
• Moves the spool towards the front to keep it clear from any walls.
• Very compact simplistic design.
• Maximum Spool Width: 90mm

Easy printing was not a high priority during the design phase, take it as a challenge. Highly recommend to go with a serious material like PC or Nylon, PETG and PLA are no good for this design. Go with 8 Perimeters / Wall Loops to give the part some strength.

Versions:

V6

- Initial Release