A stand for combining a Flex Radio Systems FlexControl and a Stream Deck XL (32 button).  This stand places the Stream Deck at fingertip height when using the FlexControl and adds additional control and function buttons when operating the radio software.  Both the FlexControl and the Stream Deck drop in without additional hardware.  The USB cables for both devices route out the back.  

I used ½ inch diameter Clear Adhesive Bumper pads on the bottom of the stand to keep it from sliding around my desk.  These bumpers are not necessary, but I modeled locating circles on the bottom of the console.

If you have a StreamDeck MK.2 or the original 15 button StreamDeck, check out my other design at:  [https://makerworld.com/en/models/1699714-flexcontrol-and-stream-deck-mk2-stand#profileId-1802421](https://makerworld.com/en/models/1699714-flexcontrol-and-stream-deck-mk2-stand#profileId-1802421)

I recommend as much support as possible under that top edge and I've painted in additional support in the .3MF file.

Update:  Revision 2 is based on real measurements provided to me for the XL instead of my assumptions.