This is my first model on here so any suggestions welcome. Please read below as you need another file too.

I have been using a ring light when doing my DIY/postprocessing stuff and it was too low as it screwed directly onto its tripod, so I designed this extender, eliminating the shadows from my hands/tools, while keeping it decently balanced at ~45 degrees.

This specific ring light, as most on the market, uses M6 screw size. Please test your size before printing. 

As this model is a work in progress, at the moment, it is designed with only this in mind, and is only designed with both of its ends as F. This means that for the time being it is only compatible with ring lights that have a base with a screw, and the ring light itself can also have a screw (eg using the phone attachment part to connect it). I will be adding other versions in due time.

For this extender, you will also need 4 x M6 square screw nuts from the amazing set that TuTu (@yujixun) has made here. I strongly recommend printing these at 0.8mm layer height. 2 of these nuts go on each side to give enough threads for your bits to screw in, usually ~8mm-1cm.

Last but not least, this model is approximately 23cm in height.

Thanks for taking the time to read and feel free to leave me any feedback!