A compass for the item frame I designed. This item uses two of the neodymium magnets (check the bottom of the description for the link). I have also included two additional magnet holes that stick out of the model, in case you want to add two extra magnets after the item is finished printing. The profile will have the pause necessary to insert the magnets at the right time. The magnets should fit snug, so no super glue is required to hold them in place. Just be sure to insert the magnets in the right direction so they attach to the item frame correctly!

This model is support free and does not require the AMS. If you are not using the AMS, just be sure to add color switch pauses at the same layers as in the print profile.

This model has two pauses within the profile. For the first pause, this is where you will insert the two magnets. The second pause is for people who have one AMS (like me) and need to add the red filament, in order to print the needle of the compass. You will insert the red filament into slot one. You should also map the red filament to use AMS slot A1. I have attached an image of what the AMS slots should look like when you go to send the file to your printer.

The five different colors/brands I used in sequence are:

El3goo Black Rapid PLA+

Inland Gray PLA+

Inland Light Gray Tough PLA

El3goo White Rapid PLA+

El3goo True Red PLA

The link for the magnets is included in the item frame model on my page:

[https://makerworld.com/en/models/1249292-no-ams-needed-minecraft-item-frame-magnetic#profileId-1271479](https://makerworld.com/en/models/1249292-no-ams-needed-minecraft-item-frame-magnetic#profileId-1271479)