Reticulated Python Bookmark

For reptile fans. This coiled reticulated python slithers through pages along with you.

More Reptiles, if it is not on MakerWorld, it will be on Patreon.

Reticulated Python

Pictures shown are printed in an 0.2mm Nozzle
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Orange Transmission Distance: 7

PLA BambuLab Basic Jade White Transmission Distance: 4.6

PLA BambuLab Basic Gold Transmission Distance: 5

This print uses 4 unique filaments

Swap Instructions:

Start with Black

At layer (0.88mm) swap to Orange

At layer (1.12mm) swap to Jade White

At layer (1.2mm) swap to Gold

At layer (1.36mm) swap to Jade White for the rest.

Can be resized to accommodate your printer or preference by adjusting the X and Y axis the same percentage while leaving the Z axis at 100%. The best way to achieve this: With Uniform Scale checked, adjust the Y axis to the desired size (this will ensure the X axis is the same proportion as the Y axis), uncheck the Uniform scale, adjust the Z axis back to 100%, slice plate, and print. Stringing may occur with Hueforge, just use a lighter to whisk them away.

Descripción