clarit · led lamp

small modern minimalist desk lamp design for the LED kit

important · make sure that:

• your filament is dry and calibrated
• your build plate is properly clean so that there aren't adhesions issues and lifts during the print
• the connector requires supports to print cleanly, i highly recommend to use a non bonding material as a raft and interface layer - in this case connector is PETG and the interface layers are PLA, and the print profiles is configured as such. If you choose not to have a different material as support interface you'll need to adjust the support settings accordingly, and ensure you clean-up completely after support removal, which can be challenging given the small area, recommend using needle nose pliers

assembly

• pass the LED kit cable from one of the slots on the base top and place the led light in position
• insert the connector with the tabs matching the respective slots on the base
• place the shade in the connector

photos show printed in matte PLA and PETG-HF

• .40mm nozzle
• adaptive layer height on the base and .2 layer height on connector and shade
• 15% cubic infill
• supports on the connector with PLA as raft and  interface layer - settings adjusted accordingly
• normal supports on the base
• brim ears

notes

• includes bambu studio 3mf files and STLs
• all photos uploaded are of the actual printed model, and are copyright protected
• if you enjoy this model please consider to buy me a coffee
• commercial licence membership available on the link below or on my patreon