Add a little flair to your Apple Watch Ocean Band!

These are literally just little sticks that you can print in any color(s) and add them to your Apple Ocean Band. They fit just snug enough to stay in but are still easy enough to remove. 

One note: depending on where you keep the clasp that holds the excess part of the band, it might be a little tough to get it to clip over since these are now taking away the “squish” as the holes are no longer hollow.

If you have troubles getting the clasp over this part of the band you have 2 options:

1: Remove the last insert and leave it out

2: Remove the last insert, put the watch on, then put the insert back in. This would actually add some security helping prevent the band from falling off as well. Of course you might need to remove it again to take the band off depending on your situation.

I printed these in in PLA standing up with a brim. After brim removal I took a heat gun on low heat to smooth out any of the rough edges left by the brim. Be careful doing this as you can quickly warp the stick.

My band used 27 sticks, the files include a few extras. 

Hope you enjoy this simple upgrade!