If you want to sell prints of this model, as well as all of my models - future and past
Subscribe to My Patreon:

Or Subscribe for a commercial License Directly in Maker World:
 

Stack o’ Jacks is a Halloween ready bookmark with four expressive jack o’lantern faces stacked from top to bottom for maximum mischief and mood 🎃🧡 Perfect for spooky season reads, market tables, and gifts that need a bold pop of pumpkin energy 🖤📚

Features:

• Four distinct expressions from cheeky grin to full grump for instant character and fun page breaks 😏😮💨
• Slim, rounded profile that sits flat and stays comfy in paperbacks and hardcovers 🪄📖

Maker notes:

• While the included profiles are carefully optimized for a 0.4 mm nozzle to retain detail across different settings, this model is still best printed with a 0.2 mm nozzle for the sharpest ribs, phalanges, and frame curls 🧩🖨️

   

• Make sure to clean the build plate with dishwashing soap and warm water before printing. Handwashing soaps should never be used to clean build plates because moisturizers can harm adhesion 🧼💧

   

USE A LIGHTER! - a quick pass with a torch on the printed parts will get rid of the inevitable stringing that comes with this type of models.
 

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA Jayo Black Transmission Distance: 0.3 / Amazon
PLA BambuLab Mistletoe Transmission Distance: 0.8
PLA 3D Jake Eco PLA Orange Transmission Distance: 2.6
PLA BambuLab Sunflower Yellow Transmission Distance: 4

Color Pallete:

Swap Instructions:

Start with Black
    At layer #9 (0.81mm) swap to Mistletoe
    At layer #11 (0.97mm) swap to Orange
    At layer #18 (1.53mm) swap to Sunflower Yellow for the rest.