Multiboard Bedside Tray Organizer:

This is an adaptable bedside organizer that allows you to build and change your organization with all the benefits of MULTIBOARD.

I created this remix to utilize the MULTIBOARD system to avoid having a full reprint as phones change or the things I carry in my pockets change. 

This print includes (1) Tray Base, (1) Bolt Lock apple watch charger, (1) Bolt Lock Apple Mag Safe Charger, and (2) Support Arm Brackets. 

Additional parts are needed: (1) 9x9 MULTIBOARD border tile, (8) Small Thread MULTIBOARD Clips, (11) MULTIBOARD snaps, and (11) MULTIBOARD T-Bolts. + any additional MULTIBOARD accessories you desire. 

Links:

9x9 Tile: [https://thangs.com/designer/Multiboard/3d-model/9x9%20MU%20Single%20-%20Multiboard%20Border%20Tile-1320756](https://thangs.com/designer/Multiboard/3d-model/9x9%20MU%20Single%20-%20Multiboard%20Border%20Tile-1320756)

Small Thread Clips: [https://thangs.com/designer/Multiboard/3d-model/Small%20Thread%20Clip-1368648?source=Recent](https://thangs.com/designer/Multiboard/3d-model/Small%20Thread%20Clip-1368648?source=Recent)

Snaps: [https://thangs.com/designer/Multiboard/3d-model/Moderate%2520Weight-Bearing%2520Snap-1311034](https://thangs.com/designer/Multiboard/3d-model/Moderate%2520Weight-Bearing%2520Snap-1311034)

Locking Bolts: [https://thangs.com/designer/Multiboard/3d-model/Locking%2520T-Bolt-1310062](https://thangs.com/designer/Multiboard/3d-model/Locking%2520T-Bolt-1310062)

Notes:

• Threading the small thread clips is hard, I first thread them through the bottom of the tray and then found they were easier to thread through the top. 
• Build out the snaps/bolt lock on the 2 snap side of the bracket and attach to the 9x9 tile, place the snaps into the tray, and then click the tile into the tray and the brackets should line up to get the bolt locks in through the bottom. 
• I moved the charging cable hole to the rear of the apple watch charger after printing it. During design I forgot to move this before my print and did not want to waste the plastic. the featured design has the hole at the rear. 

Remix:

The remix consisted of utilizing the Multiboard small thread, snaps, and bolt locks in order to create a tray base that would snap into the existing MULTIBOARD ecosystem. there are two snap negatives and eight small thread negatives in the tray base that enable this. the bolt lock hub positive was used to create the brackets from the tray to the 9x9 tile and to allow the magsafe chargers to attach to the tile. 

This is a remix of the multi board platforms (Tiles, and Bolt locks)

[https://www.multiboard.io/license#appropriate-credit](https://www.multiboard.io/license#appropriate-credit)