I saw the work done by MichMaker11B and kinda ran a bit further with it replacing the driver and passenger door nets in my 2022 Ford Bronco with extra pockets and a cup holder. The cup holder attaches to the large pocket using 3 m4x8 screws (6mm or 10mm length should work too) I printed with ASA but also had people in the Bronco forums print with PETG so personal preference really.

I added tabs to the thin walled parts that will need to be trimmed off before installed, this prevented me from having to do a raft when printing.

Install
1) remove the 6 screws holding on the door net

2) remove the door net from the frame

3) screw the large pocket to the cup holder using m4x8 screws

4) locate all the parts over the posts on the frame from the bronco 

5) screw back down
 
Removable bins for the Large pockets linked below
[https://makerworld.com/en/models/2218370-bronco-door-pocket-inserts#profileId-2412257](https://makerworld.com/en/models/2218370-bronco-door-pocket-inserts#profileId-2412257)