Two versions, a red, white, blue and black one and a black and white one.

Prints best at .2mm nozzle but .4mm also works

For COLORED VERSION use colored file

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
You may print at higher layer heights below the Base Thickness of 0.4mm
The Max allowed Thickness is 3.12mm and the Actual Thickness is 2.72mm

Filaments Used:
    PLA PolyLite Black  Transmission Distance: 0.3
    PLA BambuLab Basic Cobalt Blue  Transmission Distance: 1.2
    PLA BambuLab Basic Red  Transmission Distance: 4
    PLA BambuLab Basic Jade White  Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #5 (0.48mm) swap to Cobalt Blue
    At layer #8 (0.72mm) swap to Red
    At layer #12 (1.04mm) swap to Jade White for the rest.
 

For BLACK AND WHITE use grayscale file

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.56mm and the Actual Thickness is 1.36mm
    PLA PolyLite Black  Transmission Distance: 0.3
    PLA BambuLab Basic Jade White  Transmission Distance: 5
This print uses 2 unique filaments

Swap Instructions:
    Start with Black
    At layer #7 (0.64mm) swap to Jade White for the rest.