Spinning Daisy Bogg Bag Charm 

Here is a three-dimensional version of an earlier Bogg Bag model we made. There are several plates because there are three options to the model. First there is the base model which is just the rotating daisy by itself--for this option, print the Flower and Stemless Bushing plates. Second is the spinning daisy on a stem with leaves--for this option, print the Flower and Bushing with Stem plates. Finally for the third option for a daisy as a potted plant, print the Flower and Stem with Pot plates. NOTE: the Stem and Stem with Pot options are sized to fit the Large/Original Bogg Bag Size. The Flower with Stemless Bushing should fit other variations of Bogg Bags.

Assembly will be required. The center axle for the daisy snaps in place after aligning the small pins. You can add glue (Super Glue/cyanoacrylate) to the surface before assembly, but it may not be necessary. 

This design includes our new Bogg dot design which features clips that can be installed after they are pushed into the bag. There is also a retainer clip for the axle that is put in after final assembly. See assembly pictures below.

The Stem and Stem with Pot Options will have two attachment points on the bag. The Bogg Dot Clips should insert vertically from the top of the bag pushing downward. The axle clip should insert horizontally. When inserting the Stemless Bushing if the raised pin is postitioned to the right, the same instructions should apply. 

Please be sure to let me know if you have any problems with printing. Everything printed fine on an A1 Mini with 0.4mm nozzle.