Robot Doodle Disc

Spin to Create!

This rotating stencil disc will help you draw a Robot!

The stencil holder is included with both AMS version an a non AMS version (you can color it with a sharpie)

There is an enhanced stencil holder that uses magnets to keep the paper in place, you can find that model here.

How to use

You line up the notch in the stencil with the mark on the holder and then trace the corresponding slot/hole in the stencil.

Then move to the next notch and do it again:

After the first three in this example, this is what the picture will look like if you lift up the stencil:

Once you have finished all of the numbers, when you lift up the stencil, you will have a finished drawing:

Tip

There is a rectangle on the stencil that shows you where the drawing will be when the notch with the 1 label is aligned with the top. This is useful for placing stencil drawing next to each other and knowing where to look when searching for trace lines.

You do not need to go in order from 1 then 2 then 3, etc. I often start at 1 and then just turn the disk clockwise to the next notch and continue until I get back to the 1.

Doodle Disc models were inspired by the Twist Art series from THIMM1