––– Button Module –––
for
BambuLab P1S
 

This button housing was designed from the ground up for the Bambu Lab P1S, created as part of my Raspberry Pi time-lapse camera project. (coming soon)

It adds a dedicated power button option using a standard 8×8×8mm push switch, plus rear cable routing clearance for a tidy, easy-to-integrate setup.
 

The model focuses on practicality — fast and simple to print (23 minutes), easy to assemble, and compatible with widely available components. It’s a lightweight, adaptable solution for anyone adding electronics or accessories to their P1S.
 

Highlights:

• Fits standard 8×8×8mm push buttons (momentary or latching)
• Added rear cable routing for clean wiring and module integration
• Streamlined design for faster, reliable printing

• Built from scratch for flexibility and ease of use

  

   

Hardware used:

Momentary Switch (8x8x8mm / 8x8x13.5mm including the pins): [https://amzn.to/48jVQwN](https://amzn.to/48jVQwN) 
or
Latching Switch --same size-- (if required by your project)

(Kit) Screws (2.6x10mm & 2.6x8mm): [https://amzn.to/4npy6fj](https://amzn.to/4npy6fj) 

Wires

The links are Amazon affiliates—at no extra cost to you, they help support my work and the creation process. Thanks!