This articulated squid can be printed in sections so that the parts can be colored without AMS. The pieces snap together during assembly, so no glue is required.

Experiment with color combinations to make this little squid fit various environments!

Assembly:

Push the ‘eyes’ part into the head part, use the 'Back' text in the eye part to orient it. the front side of the head is where eyes are more visible from (the 'eye sockets' look larger).  

(make sure the eyes part dont rotate during insertion,  which would make the pin stuck in it at the next step)

Push the pin through the head part with the eyes in it.

The pin with the tentacles also has a 'Back' text in it to help with orientation.

Finally, push the mantle onto the end of the pin until it snaps into place, holding the whole model together. 

(The mantle is symmetrical, so no front/back sides)