tarting from the fantastic Rugged Box created by Whity decided to add an handle on top of the lid.

Design is parametric, unfortunately I wasn't able to be precise as the model from Whity, but in theory it should work.

Areas to improve:

• Handle is not properly in perfect equilibrium, I think it's needed to move the joint between lid and handle a little bit more toward the center of the lid, otherwise it slightly unbalanced.
• Handle when flat to the lid is not very easy to be managed. Fillet of the lid might be revised (or even just made it shorter)
• Create a small cavity in the handle to raise it easier.

Important:

I printed the lid with support with very good result, but pls remember to exclude the external joint (took to me a couple of hours to push screw in the hole :(

Additional material needed:

8x M3x35mm screws

8x M3 nuts

Feel free to shoot any question or any suggestion to improve the model.