⚙️🤖 Mechanical Robot Hand – Version 5.0 🦾
The evolution continues! Inspired by your feedback and fine-tuned through every version, V5.0 takes mechanical precision and creativity to a whole new level. Built stronger, smoother, and now fully modular — it’s the most customizable version yet!

👉 How it Works

Slip your fingers into the rings, pull the levers, and bring the mechanical hand to life. Three fingers and the thumb move in sync – and the clever pinky still doubles as the thumb trigger! 🖐️

✨ What’s New in V5.0

• Even More Stable → enhanced rod connections and refined gap tolerances for smoother motion and lasting durability.
• A1 Mini Compatible → ready to print and perform perfectly on compact printers.
• Fully Modular Build-Up → mix, match, and extend your own creation — choose your style and length (even 1 meter is no problem 😉).

Build Setup:

💬 Powered by the Community

This version exists thanks to your feedback, ideas, and creativity. Every tweak and improvement in V5.0 was shaped by your input — so thank you for helping bring this hand to life!

Reliable / Easy Connection System:

If you’re using only one connection (for example, the hand and fingers without any extension), no glue is needed. If you decide to extend it further, assemble it to your desired length, test the fit, and then apply a small amount of super glue to secure the connection—this ensures it stays firm even when the hand bends.