iPhone Air Camera Protector (Case Friendly)

Designed to cover the exposed area created by some cases. Compatible only with the iPhone 17 Air/iPhone Air.

The smallest ‘camera only fit’ should be the most case friendly but it doesn't have anything to stop it from rotating other than the friction on the camera ring. However, if used with a case, the rotation shouldn't be an issue. I have included some other variants that extends further down the plateau to help stop the rotation if needed.

You can also use it without a case as a wobble stopper as well as a camera protector since the lens is recessed behind the surface of the print. It will also lift the lens off the surface you place your phone on.

Feel free to let know if you have any suggestions on how to improve.

Print with the tapered end facing down to make sure the surface contacting the camera plateau is smooth. Ironing is preferred but you can also get away with not using it. No supports needed if printed in the default orientation. Recommended layer height is 0.12 for best quality and fit. I cannot guarantee it will fit as well with higher layer height.

Descrição