I was Having an issue printing in the front left corner of my H2S. The PTFE Tube was pulling and kinking creating an error AMS Overload.

I took the PTFE Tube from the AMS and the one from the inside of machine and measured and cut the AMS one 2" Longer and swapped them out but still got the AMS Overload message. 

So, I created this Buffer Guide for the PTFE Tube. The hole in the guide is concentric with the hole in the Buffer; I applied it with 3M VBA Double Face Tape that can be found on Amazon.

I printed the part out of ASA so it could handle the heated chamber. 

3M VBA Tape: [https://a.co/d/hQ58miS](https://a.co/d/hQ58miS)