Estás en 3DFinder
Buscamos en Thingiverse, MakerWorld y Printables al mismo tiempo para darte lo mejor de cada una.
Descripción
Update:
26.10.2025 v.1.3 : Two-color book added. Cover and pages printed separately. After printing, glue them together
04.10.2025 : I improved the ghost a bit so that it prints better.
09.10.2025 : I added two version of ghost with exact place for tealight and RGB light. Now the lights don’t fall out from the inside.
However, a small downside is that in the case of a tealight, those inner supports create a bit of extra internal shadow. Besides that, the ghosts with these light holders cannot be scaled.
Overview
A charming little ghost reader sitting on the edge of a shelf with a book in its hands. The model is designed to fit on a shelf and serve as a cozy decorative piece. When printed with translucent filament, it can glow if you place a small light source (e.g., an LED) inside, turning it into an atmospheric lamp. A magical mix of humor and design – perfect for Halloween book lovers.
Tips.
It is important to print this ghost with low layers on the top like in the print profile.
If you print the book with glow filament it gives interesting effect like on the photo below.
Check also my other Halloween designs in my collection :)
Have Fun:)
Media:
Check 1min 35 sec
