I didn´t like original camera view of my A1, so I was looking for models with better view.

BEWARE YOU MUST REMOVE CAMERA AND ITS CABLE !!!

But I didn´t find any model perfect for me. So I was inspired by this model: 

[https://makerworld.com/en/models/1797576-a1-camera-relocation-omnidirectional#profileId-1916609](https://makerworld.com/en/models/1797576-a1-camera-relocation-omnidirectional#profileId-1916609)

I created my own version without moving parts. Only bit of glue.

1. Remove camera from original location. Use this instruction page: 

     [https://wiki.bambulab.com/en/a1/maintenance/camera-replacement-guide](https://wiki.bambulab.com/en/a1/maintenance/camera-replacement-guide)

2. Remove camera cable from metal sleeve. Use this instruction page (do not remove USB-C cable, only camera cable!):

     [https://wiki.bambulab.com/en/a1/maintenance/usb-c-cable-replacement-guide](https://wiki.bambulab.com/en/a1/maintenance/usb-c-cable-replacement-guide)

3. Connect printed camera part with tube connector with glue:    

4. Insert camera module into printer camera part:

5. Push camera module to front:

6. Install printed display frame:

7. Push camera cable thru hole:

8. Push camera cable thru valve and insert into camera module:

9. Insert valve into hole in the display frame:

10. Install camera part cover:

11. Set up camera view as you wish:

Hope yu´ll be satisfied!