The Pop a Chip Rocket is a fun rocket that combines 3D Printing and eating some chips from a can!  You will need to munch on some chips from a can for this rocket to get built, so be much away!  

Suggestions for chips in a can that work are:
•    Standard Pringles (https://a.co/d/6maL1DQ) 5.2 oz can
•    Cheetos (https://a.co/d/cMEkAeH)/Doritos (https://a.co/d/1O3FcHA) Minis can

Other brands may work, if they are the same diameter and meet or exceed the length of a standard Pringles can.

Try and build an entire colored fleet of Red, Green, Blue, Yellow, and Purple can rockets!

Recommended engines are:

Aerotech E30-7

Aerotech F44-8

For launch, requires or equivalent:
Estes 1/4" Launch Rod (https://estesrockets.com/products/1-4-two-piece-launch-rod?srsltid=AfmBOorQpgFCDG9G7C-eX4fznRmAyKLcyUS3_BFrwT-ONxVKlKxRxUsZ)
Estes Launch Pad and Controller (https://a.co/d/6GVHlgY)

# Change Log
* 9/24/2025 Initial
* 9/25/2025 Added launch equipment
* 9/25/2025 Fixed an issue with the Fin object and updated print instructions for it. Use the On Build Plate Only.