Hi!

I found KobaRileys cabke guide for the buffer (https://makerworld.com/en/models/142877-cable-tidy-x1-p1s-p1p) but only realised after printing that it does not fit the AMS Hub.

As there were multiple people (including me) requesting an AMS Hub version I set off designing one.

For mounting it, you can just hang it off the AMS Hub, but optionally you can use some 2 sided tape on a couple of spots.

Please note that due to the size of the AMS Hub, a small part of the poop chute is blocked, which may cause some poop slides to not fit.
The one I used still fits it's TrocheHole's poop chute (https://makerworld.com/en/models/201311-poop-chute-basket-outlet-for-x1c-p1s-p1p)

I hope you like it. 
 

I am also figuring out a way to take care of the excess amount of cable for the 6 pin bus cable which is way to long in my case.