A sink basket for drying your dish sponge. This will fit any sink, including curved ones. It's also easily removable for cleaning.

The basket is parametric - if you need a different size, use the customize function. You'll need to print the contact pads from the Contact pads only print profile.

Installation is very simple and only requires some mounting tape. Steps:

1. Print the components and remove the brims from the contact pads.
2. Clean your sink surface and your print surface to prepare it for mounting tape.

3. Put mounting tape on the contact pads:

   

4. Put the basket on the contact pads.

   

5. Press the basket and the contact pads to your sink. The contact pads can swivel, conforming to curved surfaces. Apply sufficient pressure to make sure the contact pads stick to the sink. Gif below demonstrates how the pads conform to sink curvature:

   

6. Now that you used the basket to position your contact pads, the pads will stay appropriately spaced. You can go ahead and take the basket off and on as you please.

   

7. Enjoy!