I wanted to create something to make it a bit easier to photography and film some of my smaller to mid size figures and this is what I came up with. Works really well for what it is. I'm sure there are some super nice ones out there but for a few quick prints and one bearing and your off to taking some cool photos and filming some nice quick short videos.

I used a 608 2RS Ball Bearing size (8mm x 22mm x 7mm)

Here is one spot on amazon you can get some if you don't have any.

[https://www.amazon.com/gp/product/B08XVFSZTF/ref=ox_sc_act_title_1?smid=A3V84ASJQQ5YY4&th=1](https://www.amazon.com/gp/product/B08XVFSZTF/ref=ox_sc_act_title_1?smid=A3V84ASJQQ5YY4&th=1)

The bearing pushes into the top plate first and should be flush once inserted correctly. Then you line the bottom plate up and carefully slide it in a bit and flip it over and apply a little pressure in the middle to finish pushing it down all the way. No need to force it. It will seat down and then you are ready to start taking pictures and shooting videos.

-------------------------------------------------

If you want to you can also 3D print a 608 bearing right here from maker world from the link below.  It works descent for being 3D printed!  

[https://makerworld.com/en/models/1083205-bearing-generator-parametric-ball-bearings#profileId-1075444](https://makerworld.com/en/models/1083205-bearing-generator-parametric-ball-bearings#profileId-1075444)

I found it easier to push the 3D printed bearing onto the bottom plate first then install the top one.