So you want small parts bin that barely uses any filament, has a locking lid, and prints really fast? Well obviously you do, you clicked on this model!

If you want an incredibly rugged and super durable bin that can withstand an explosion, this isn't the model for you. This model is for people who want the most storage for the least amount of filament. For most people this bin should be durable enough.

Sizes

These use standard gridfinity units for sizing.

1x1x3 - 21mm tall

1x1x4 - 28mm tall

1x1x5 - 35mm tall

1x1x6 - 42mm tall

10 Second Assembly

It doesn't get easier than this. Just muscle the lid onto the rails, as shown in the picture below. Make sure the finger handle is going in the same way as the picture. Reversing it won't work. Once it's in there it'll be secure. It won't come out on it's own during normal use. You'll have to really muscle it back out to remove it.

Stacking

These are stackable and use standard gridfinity units for height.

If this gets a good amount of downloads then I'll make a parametric version so you can make it any width, length, and height.

Less Filament Philosophy - See my profile for more models like this