This is the five-petaled lily-like flower found in the Nier video game series.

Highlights:

• Great for cosplay or home decor
• The petals, stem, leaves, and base are all separate parts so you can use the petals for other things
• The stamen of the flower makes use of your printer's purge lines
• Prints well with glow in the dark filament for a glowing flower

Filaments used:

• Petals (matte white): [https://amzn.to/42BB9HM](https://amzn.to/42BB9HM)
• Petals (GITD blue): [https://amzn.to/3uDrQdH](https://amzn.to/3uDrQdH)
• Stem, leaves, and base (green): [https://us.store.bambulab.com/products/pla-tough?variant=41002792288392](https://us.store.bambulab.com/products/pla-tough?variant=41002792288392)

Printing notes and assembly:

• This can be printed on one plate or four plates (for petals, stem, leaves, and base)
• If making any changes, ensure the following:
  • Petals and leaves have tree supports enabled
  • Petals and leaves have adaptive layer height enabled
• To get the color of the tip of the stem to match the petals, use an AMS or add a pause around height 152.20 to swap colors
• From my testing, you may need a tiny bit of pressure to attach the petals to stem and stem to base but it should stay secure
• BE CAREFUL WITH THE LEAVES — INSERT THEM INTO THE STEM AT AN ANGLE

• For the stamen (center hole at the top of the stem), I’ve tested it to have a snug fit with around 4-6 purge lines (only 1-2 lines needed if you're resourceful with your folding/cutting)
  • Fold each purge line in half
  • Insert the folded line into the base until no more can fit
  • Cut the lines to your desired length
  • Use your finger to press down into the center hole and fan out the cut lines