Note: This design only changes the stock magentic dock adapter with the Panda Touch, no changes to the Bambu lab printer parts

*** Update to the full surround mount, I have included a small hole to allow access to the buckle on the stock screen to help remove in the future if needed, should be able to fit a small stock allen key. I have also add an additional full surround mount for those of you who have an AMS riser so it does not overhang the top of the printer. Both based on the request and testing by rembomy thanks for the help on this ***

Completly updated my v1.0 mount thanks to Martin Löwe for pointing me in the direction of the step file on BTT github. This version creates a new magnetic dock so you don't use the one that came with the screen just some of the components of it.

The parts you need to remove and transfer from the stock dock are:

• Charging circuit board + its 4 retaining screws

Then you will need the following:

• 5 x 8mm x 2mm magnets (I only have 3 remaining from some other jobs hence two missing in my picture)
• 2 x M3 x 12mm bolts for attaching the enclosure to the adaptor.

Then to create the dock you (for images follow along on the images in the profile):

1. Remove the circuit board from the original dock (4 x screws)
2. Replace the circuit board into the new dock using the 4 original screws (they cut thread into the printed part)
3. Glue the alignment pegs into the two shallow holes (this allows the part to print flat and minimise supports)
4. Check the polarity of the magnets on your screen and glue these into the 5 tight fitting holes so they will attract the screen

I have made cable channels for either side of the screen and checked it doesn't hit any of the original screens buttons but any issues please shout so I can improve it for everyone. This also is no longer tight with the stock cable that comes with the Panda touch.