This simple tool makes it much easier to line up your new grips on your golf clubs. Fits both standard and midsize grips! (I haven't tried any other sizes yet)

Easy to use:

1. Slide the tool over the end of the grip as shown in the pictures. Make sure it is snug to the grip to make sure that you get good alignment.
2. Apply grip to club as normal.
3. Adjust the alignment of the grip by looking through the slot cut out of the tool. I have found it best to line up one of the edges of the slot with the grooves or leading edge of the clubface.
4. Remove tool by sliding it off, and you're all set!

I've used this tool when regripping my entire bag and found it to be very helpful. Hope it makes gripping clubs at home just a little bit easier for you too!

Can be printed in either PLA or PETG, only 12-13g of filament.