This is a stylish lamp shade for E14 bulbs.

It has a rough texture and does not look 3D printed. In fact looks like an expensive lamp, no trace of printing layers.

I used PLA matte white and its amazing how it looks.

ATTENTION! heat from the bulb could melt the plastic! In my case im using 8W “Edison style” bulbs and the heat is just warm, and the plastic wont melt because of this, but be careful on the heat of your bulbs!

For the bulb holder I used an E14 (E27 will not fit) holder bought on aliexpress: [https://aliexpress.com/item/1005004524711258.html](https://aliexpress.com/item/1005004524711258.html)

For the cable I used this: [https://aliexpress.com/item/1005008807522684.html](https://aliexpress.com/item/1005008807522684.html)

In the same print profile there is a rounded cap to place over the bulb holder and hide it. I designed it, but never printed so its not tested.

Be careful if you change settings to my print profile as you may loose the fuzzy skin settings. It will add several hours, but its a must to make it looks SO GOOD. I promise its worth it!

You may need the cable grip for the E14 bulb holder, you have it here: [https://makerworld.com/en/models/1782353-cable-grip-for-e14-e27-bulb-holder](https://makerworld.com/en/models/1782353-cable-grip-for-e14-e27-bulb-holder)

Also if you need the ceiling canopy, this is my design: [https://makerworld.com/en/models/1782323-ceiling-canopy-for-hanging-lamp](https://makerworld.com/en/models/1782323-ceiling-canopy-for-hanging-lamp)