Be sure to visit my profile page to find more fantastic models!
[https://makerworld.com/en/@cP3D](https://makerworld.com/en/@cP3D)

I have created another clock here. Perhaps some of you will also like this clock.
I could imagine that this clock would also make a very nice gift for someone.

I have created a 170 mm and a 245 mm version for wall and table use

If you wish to enthuse others about these wall clocks, please share the link on social media.

Here you will only find the clock faces!
The necessary accessories can be found under the following link:

[https://makerworld.com/en/collections/4894074](https://makerworld.com/en/collections/4894074)

To minimize print time without compromising quality, I have configured height range modifiers in my print profiles. So don't be surprised if the swap commands do not match the data in the print profile

Instructions on how to print with up to 7 colors using only an AMS can be found for this model:
[https://makerworld.com/en/models/786167-wall-desk-clock-the-grinch](https://makerworld.com/en/models/786167-wall-desk-clock-the-grinch)

Print at 100% infill with a layer height of 0.06mm with a base layer of 0.12mm
 

Swap Instructions:
    Start with Black
    At layer #19 (1.2mm) swap to Blue
    At layer #23 (1.44mm) swap to Jade White
    At layer #32 (1.98mm) swap to Black
    At layer #33 (2.04mm) swap to Red
    At layer #37 (2.28mm) swap to Yellow
    At layer #40 (2.46mm) swap to Jade White for the rest.

If you receive the message about overhanging regions during slicing... you can ignore it
 

Here you can find my other collected clock faces
[https://makerworld.com/en/collections/1715414](https://makerworld.com/en/collections/1715414)