This is a complete set of Brackets and various accessories that was created for a 2x2 (4 total) LED Matrix project. Its primary function is for running Pico-8 (Fantasy console) natively at 128x128 pixels. 

This set includes (each on a different plate):

1. Basic bracket set - for initial assembly all on one plate.
2. Short tie up brackets - for securing wires via zip or wire ties.
3. Button Mount - for an optional 9.9mm diameter momentary switch (can ealsy be modified within the app)
4. Basic speaker mount - mounted to the top or bottom (designed for use with [https://a.co/d/9bWrsTF](https://a.co/d/9bWrsTF) )
5. Horizontal speaker mount - top or bottom mount, lower profile and channels sounds out while protecting the speaker. Same speaker type as other.
6. Raspberry Pi 4 mount - for mounting the Rpi4 within the LED matrix on the back
7. Basic Stand - good for initial setup
8. Fancy Stand - more finished look, does not work well if there is a lot of weight in the back of the panel
9. Sturdy Stand - beefier stand, works for all applications but more hefty.

These parts were all designed specifically for the Ali Express P3 panels (192mmx192mm, 64 pixel) [https://www.aliexpress.us/item/3256806698616895.html](https://www.aliexpress.us/item/3256806698616895.html)

M4 screws - 6mm or 8mm both work. Used this kit: [https://a.co/d/3W3Cr1V](https://a.co/d/3W3Cr1V) 

M3 screws - 2 for the speaker mount (m4 could work, but would need to widen the hole)

Also check out the optional rear panel cover for this project (the complete how-to is also included here):

[https://makerworld.com/en/models/1777884-led-matrix-p3-assembly-rear-panels](https://makerworld.com/en/models/1777884-led-matrix-p3-assembly-rear-panels)

Pico-8 Joystick Housing: [https://makerworld.com/en/models/1777844-pico-8-joystick-controller](https://makerworld.com/en/models/1777844-pico-8-joystick-controller)