This is a mount for an aftermarket Lightburn Compatible camera from Amazon. Lightburn is currently sold out so I needed a different option. The issue was, when the camera arrived it had a heatsink attached not shown so it needed a new holder.  This uses M3 hardware for the nuts and caphead m3 bolts.

The design includes a method for aligning the camera on the center line as the camera is slightly offset from the board.  The alignment is listed on the base of the model. There are two options, one with cable management for zip ties built in and one without. Labeled individually in the print profile.  I also used some cable ties from Makerworld to run the wires which I'm listing below.

Camera used:

[https://www.amazon.com/dp/B0BWS4R1BH?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1](https://www.amazon.com/dp/B0BWS4R1BH?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1)

Cable mount zip tie plates:

[https://makerworld.com/en/models/250357-cable-tie-zip-tie-mount-holder#profileId-266597](https://makerworld.com/en/models/250357-cable-tie-zip-tie-mount-holder#profileId-266597)