Show off your cool Brick Minifigures with this stackable display case! Each display case holds 8 of your most valued minifigs. The Display ensures a snug fit, while giving each unique minifigure their own cube. Their are TWO VERSIONS of this Display Case. One with studs, and one without. If you want to stack these, it is recommended to use the ones without the studs, then top if off with a studded case. You can also hook up some lighting to the back which may increase visibility of figures if printed in darker colors.

The BEST way to insert minifigures into the cubicles is to bend the legs, slide them in, then while holding the minifigure's feet, adjust the pose. It may be tricky to insert them another way, but the reason for this is to make sure that once their in, it will be difficult for the minifigures to fall out, while being very easy to intentionally remove them.

The most difficult part about this was how the interior studs printed. Printing them sideways SIGNIFICANTLY decreases supports, but it also means that the figures won't fit as nicely as they would if they were printed vertically. Just, know that if you choose to print vertically, the minifigures will fit much better, but come at a much steeper filament cost.

*****MAKE SURE TO FULLY REMOVE SUPPORTS AROUND STUDS INSIDE THE DISPLAY CASE***** ---- As this DIRECTLY affects whether the minifigures fit or not.

Don't forget to like, collect, and follow me on MakerWorld or even BOOOOOOOST!!!!!!