This is my insert for the game Knitting Circle.  This was a fun design, the lids for the player boxes turned out better than I was hoping.  This insert features magnetic lids for the component boxes, and full colour graphics on the lids.  I made use of two AMS' when printing some of the lids.  It is not strictly required, it could be done with less, but I did not want to break the last box design into two parts.

The majority of the components in this print require a single AMS, with the exception of the last plate.  I used seven colours on that plate, mostly because I was ready to move on from the design, I didn't want to go back and break the component box into two boxes, and honestly because I could.  

This insert will require the use of ca glue and 64 - 3mm by 1mm magnets.  I ordered 300 of them from Amazon for this project.  This set comes with a larger magnet that can be used to set the small magnets in place.  For assembly, place a small dab of ca glue into the magnet hole, and then use the larger magnet to press a small magnet into the hole.  Slide the large magnet to the side to finish…pulling it straight upwards can pull the small magnet out of the hole.  If you have problems with a magnet refusing to stay in place, I found that using a small ziplock bag between the small and large magnet helped, you can hold the bag in place while moving the large magnet away.

One thing to note, you MUST mark the large magnet so you know the polarity!  I marked one end green and one end red, so I could keep track.  Any magnets facing upwards were placed against green, any facing downwards were placed against red.  If you mix it up, the insert won't work, so make sure you pay attention to your polarity!